Coatings
Coatings
An
Industrial Coatings is a paint or coating defined by its Protective
Coatings,epoxy coatings, rather than its aesthetic properties, although it can
provide both.The most common use of industrial coatings is for corrosion
control of steel or concrete. Other functions include intumescent coatings for
fire resistance. The most common polymers used in industrial coatings are
polyurethane, epoxy and moisture cure urethane.
Ultimate Linings is a fast
setting, rapid curing, aromatic, two components, hybrid polyurea/polyurethane
spray designed to be applied over EPS, wood and many other surfaces. Its
excellent balance of stiffness and impact resistance provides excellent plastic
"shell-like" protection for delicate foams and EPS. Its chemical
design allows fast "user-friendly" application with excellent flow and
appearance.
SURFACE PREPARATION
In general, coating performance and adhesion are directly
proportional to surface preparation. Most failures in the performance of
surface coatings can be attributed to poor surface preparation. Polyurea
coatings rely on the structural strength of the substrate to which they are
applied. All surfaces must be free of dust, dirt, oil, grease, rust, corrosion
and other contaminants. When coating substrates previously used, it is
important to consider the possibility of substrate absorption, which may affect
the adhesion of the coating system, regardless of the surface preparation. It
recognizes the potential for unique substrates from one project to another.
FEATURES TYPICAL
*Plastic "Shell-Like" Protection
*Low Shrinkage
*100% Solids
*Zero VOC
*Meets USDA Criteria / Fast Cure
*Excellent Thermal Stability / High Productivity
*Excellent Chemical Protection
*Excellent Cold Temperature Impact Resistance
USES
Decorations / Props,
Speaker Boxes
Architectural Shapes, Dock
Flotation's,
Steel Coating, Wood Pallets
/ Crates
Food Processing Plants, Wood Cabinets
Industrial
product formulations offer solutions for abrasion resistance, water proof
coatings, blast resistance, hazardous materials containment energy, ballistic
armor, chemical resistance, energy efficient insulation, structural
reinforcement, corrosion resistance, fire retardant and thermal barrier
coatings.
Aluminum:
Aluminum should be blasted with aluminum oxide or sand, and not
with steel or metal grit. Excessive blasting may result in a warped or deformed
surface. After blasting, wash aluminum with a commercially available aluminum
cleaner. Allow to dry, then prime.
Brass and Copper:
Brass and copper should be blasted with sand, and not with steel
or metal grit. Remove all dust and grease prior to applying primer.
Galvanized Surfaces:
Clean and degrease any contaminated surfaces before priming. Do
not blast galvanized surfaces with an abrasive grit. An adhesion test is
recommended prior to starting the project.
Fiberglass Reinforced Plastic:
The gel coat should be lightly blasted or sanded with 80 grit
sandpaper and cleaned.
Plastic Foams:
Enhanced adhesion is obtained when the foam is mechanically
abraded. When coating polystyrene, do not use a solvent-based primer.
Textiles, Canvas, Fabrics:
Adhesion to most fabrics, geothermal membranes and textiles does
not require a primer.
Stainless Steel:
Stainless steel may be grit blasted and degreased before priming.
Some stainless steel alloys are so inert that it is not possible to achieve a
satisfactory bond. An adhesion test is recommended prior to starting the
project.
Ultimate
Linings Ltd.
6630
Roxburgh Ave #175
Houston,TX,
77041
(713)466-0302
Fax
No. : 713.937.0052
Toll
Free 800 989-9869
New Classified Ads